undershot

['ʌndəʃɔt]

adj.藉下面水流而转动的,下颚突出的

(undershoot的过去式与过去分词)

a.

1. (水车等)由下面水流冲击而转动的, 下射的

2. 下颌突出的; 下门牙突出的

undershot

同义词：

underslung | underhung |

反义词：

overshot |

1. (of a waterwheel) turned by water flowing under it
   （水车）下射式的（下部水流驱动的）
   
2. denoting or having a lower jaw which projects beyond the upper jaw
   下牙倒咬的，地包天式的
   

undershot

动词 undershoot:

fall short of (the runway) in a landing

同义词：undershoot

shoot short of or below (a target)

同义词：undershoot

形容词 undershot:

having a lower part projecting beyond the upper

同义词：underhung, underslung

undershot

■AXJ's growth will likely slow meaningfully, possibly even undershoot our own forecasts.

AXJ的增长有可能有针对性的减缓，甚至有可能超出我们的预测。

■Application of DSP in the Vector Undershoot Measurement of Shooting Range

DSP在靶场矢量脱靶测量领域的应用

■The SDRs limit the current, thereby reducing signal undershoot and overshoot noise.

SDR电阻限制电流,因此减少信号负过冲和超限噪声。

■"Lock the cage was opened, all the oil exploration companies have begun to Checkpoint to undershoot.

“笼子的锁开了，所有的石油勘探商们开始直往下冲。”

■Artillery troops carry on the recruit training, a some recruit artillery emits, the shell undershoot, flies in the nearby vegetable field, sees only bang's one, a person drops down accordingly.

一炮兵部队进行新兵训练，某新兵一炮放出，炮弹脱靶，飞进附近的菜田里，只见轰的一声，一人应声倒下。

■Overshot and undershot bites, missing teeth are to be faulted to the degree present. Broken teeth are not to be faulted.

上下腭中，缺牙会导致品质等级的降低。但断牙并不影响评价。

■Overshot more than 3/16 inch and undershot more than 1/8 inch are disqualifications.

上超咬合超过3/16英寸和下超咬合超过1/8英寸要被取消比赛资格。

■Undershot or Overshot bites are a disqualification.

上鄂突出或下鄂突出的咬合都是失格。

■Undershot or overshot bite is a disqualification.

上颚或下颚突出为失格。

■Specimens with teeth overshot or undershot are to be disqualified.

上颚突出式咬合或下颚突出式咬合为失格。

■Overshot or undershot bad faults.

上颚突出式咬合或下颚突出式咬合属于缺陷。

■An overshot or undershot bite is a serious fault.

上颚突出式咬合或下颚突出式咬合都属于严重缺陷。

■Overshot or undershot jaws are undesirable, the latter being more severely penalized.

上颚突出式咬和及下颚突出式咬和都属于缺陷，后者会受到更严厉的处罚。

■Overshot or undershot bite.

上颚突出式咬和或下颚突出式咬和。

■A bite which is undershot or overshot should be severely penalized.

上颚突出式咬和或下颚突出式咬和属于严重缺陷。

■The teeth meet in a scissors bite.Overshot or undershot bites are disqualifications.

上颚突出式咬和或下颚突出式咬和属于失格。

■Overshot and undershot teeth are a fault.

上颚突出式咬和或下颚突出式咬和属于缺陷。

■A bite either overshot or undershot is a serious fault.

上颚突出式咬和或下颚突出式咬和都属于严重缺陷。

■Teeth meet in a scissors bite or they may be level.Overshot or undershot bites faulted to the degree of severity of the misalignment.

上颚突出式咬和或下颚突出式咬和都属于缺陷，严重的牙齿不整齐也属于缺陷。

■undershoot distortion

下冲失真

■undershot water wheel

下射水轮

■an undershot water wheel

下射水轮；下击水车

■Undershoot Undershoot refers to the amount by which oltage or frequency drops below the nominal alue as the oltage regulator or goernor responds to changes in load.

下超调下超调指电压调整器或控制器在应对负荷变化时，电压或频率低于额定的量。

■undershot distortion

下过冲失真

■undershot jaw

下颌突出

■An undershot bite in which two or more of the upper incisors lose contact with two or more of the lower incisors is a disqualification.

下颚突出式咬和如果有两颗或两颗以上的上门牙无法与下门牙接触，属于失格。

■An undershot jaw is to be severely penalized.

下颚突出式咬和属于严重缺陷。

■Faults to be penalized are: Dudley nose, light or pink eyes, tail too long or badly carried, undershot or overshot mouths.

不合格的为：异色鼻子，浅色或粉色眼睛，长尾或尾跟位置不对，嘴过短或嘴过长。

■Severe Faults Wry and undershot or overshot bites with a noticeable gap must be severely penalized.

严重缺陷：扭曲的牙齿、上颚突出式咬和或下颚突出式咬和有明显的间隙属于严重缺陷。

■Major fault: undershot, overshot, wry mouth.

主要缺陷：下颚突出或上颚突出，齿型不整齐。

■As far as predicting the technological future is concerned, people almost always either overshoot or undershoot.

人们对技术未来的预测总是超前或落后。

■In the short run, however, soybean complex could undershoot those levels as speculative selling runs its course.

但是在短期内，由于投机性销售仍在继续，大豆类产品期价可能会低于应有水平。

■of low strain rate under strain-controlled condition, an overshoot appears at the point and an undershoot at the point .

低应变速率下的应变控制的条件下，超出现在点和下冲点。

■undershot wheel

低水位水轮

■You can use this discontinuous-control mode to reduce the cycling behavior, overshoot, or undershoot inherent in the two-position mode.

使用这种间断控制器模型减少双位置模型固有的循环行为、超过目标或未达目标。

■Bias affects the overshoot or undershoot of the motion through the keyframe.

偏见影响过头或欠该议案通过关键帧。

■Teeth Scissors bite.A badly undershot or overshot mouth is a fault.

剪状咬合，严重的下颌突出或上颌突出都属于有缺陷。

■On the other hand, in the case of high strain rate, both overshoot and undershoot do not appear.

另一方面，在高应变率，都超下冲不会出现。

■Overshot or undershot bite is a serious fault.

只允许剥除和修剪耳朵、头顶、面颊和足爪的毛发。

■Also, determine the absolute value of the maximum input undershoot in milivolts that can be tolerated by the device and still function.

同样，还要确定器件可以容忍且能继续工作的最大输入负脉冲信号(单位毫伏)。

■trailing edge undershoot

后沿下冲

■Bite - The jaw is wide and slightly undershot.

咬合：下颌宽，轻微的下颌突出式咬合。

■Bite--Jaws--The jaws should be massive, very broad, square and "undershot," the lower jaw projecting considerably in front of the upper jaw and turning up.

咬和-颌部：颌部厚重，非常宽，正方形，“下颚突出”，下颌在前面相当突出（比上颌突出），且向上翻。

■The incisors meet with a scissors grip.Overshot or undershot is a fault.

咬和为剪状咬和，上颚突出或下颚突出式咬和都属于缺陷。

■The underjaw is deep, square, broad, undershot and well turned up.

在嘴唇闭合时，牙齿不可见。下颌深，正方形，宽，下颌突出，而且向上翻。

■Overshot or undershot bite, or any distortion of the bite or jaw, should be penalized as a serious fault.

在浅色系中[注：指拥有浅色毛发的犬中]，淡红色的鼻子是允许的。咬合：应水平或剪状。

■At the points and , an excessive energy is necessaryto create a nucleus of the induced phase compared with the movement of the interface, and therefore an overshoot and an undershoot appear.

在点，过度的能源有必要建立一个核诱导相比较，运动的接口，因此超和下冲出现。

■Based on thesereasons, both overshoot and undershoot do not appear in the case of high strain rate.

基于这些原因，都超下冲不显示的情况下高应变率。

■Missing pigmentation on nose, eye rims, or lips.Eyelids round, triangular, loose or small.Overshot, undershot, wry mouth.

大白熊犬生来的时候并不是非常沉稳的，它曾经是出现在战场上的，甚至有些时候还有铁链会挂在它的颈部上。

■Jaws/Teeth : Broad with large teeth. The incisors meet with a scissor bite. Overshot or undershot is a fault.

大白鲨/牙：广泛与大牙齿。满足的门齿与剪刀咬的。超越或低于是一个错误。