reboot
[.ri:'bu:t]
v.重新启动, 再引导
词形变化：
动词过去式: rebooted | 动词过去分词: rebooted | 动词现在分词: rebooting | 动词第三人称单数: reboots |
vt.vi.
再启动, 再开动, (使)再运作
reboot[ri'bu:t]vt.1.■【计算机】重新启动，重新引导，重自展
verb
- [with obj.]boot (a computer system) again
再引导，重新启动（计算机系统）
■[no obj.](of a computer system) be booted again
（计算机系统）再引导，重新启动
- an act or instance of booting a computer system again
（计算机系统的）再引导，重新启动
reboot
动词 reboot:
cause to load (an operating system) and start the initial processes
reboot
■"An unexpected error occurred shutting down the system. Please reboot.
"关闭系统时，出现了一个异常错误。请重新启动。
■"An unexpected error occurred. Please reboot and try the installation again.
"发生意外错误。请重新启动并且试着再安装一次。
■"Cluster service has been successfully installed. You must reboot your machine for all changes to take effect. Reboot now?
"已成功安装群集服务。要使所有改动生效，您必须重新启动机器。要立即重新启动吗?
■"You must reboot this computer for the changes to take effect.
"必须重新启动这台计算机，改动才能生效。
■"Note: The above values will take effect after the next reboot of the target computer.
"注意: 上面的值会在目标计算机下一次重新启动时生效。
■"NOTE: After the configuration has been restored, your Management Console session will be closed and the system will reboot automatically to complete the changes.
"注意: 配置还原后，管理控制台会话将关闭。系统会自动重新启动来完成更改。
■"The port was not reset properly. If you wish to use the port, please reboot.
"端口复位不正确。如果要使用这个端口，请重新启动。
■"A reboot will take place to complete the upgrade process.
"要完成升级过程，需要重新启动。
■"Reboot turned off via command line switch.
"通过命令行开关来关闭重新启动。
■The nodes on the other side of a HB LAN split will determine the arbitration device has already been contacted and will programmatically TOC (reboot).
HB LAN 分割另一侧上的节点则会确定已 经联系的仲裁设备，然后进行程序化 TOC (重新引导)。
■This means Linux knows nothing about any modifications you made.You should reboot your computer before doing anything with /tmp/hda.
The kernel was unable to re-read the partition table on /tmp/hda (装买或系统资源忙路中).
■There are one or more pending delete operations which require a reboot. Would you like this program to attempt to reboot your computer now?
一个或多个挂起的删除操作需要重新引导计算机。您希望该程序现在重新引导计算机吗?
■Once you kick out the LiveCD and reboot, your original system comes back.
一旦取出LiveCD并重新启动系统之后,原系统就恢复了。
■Once the new kernel is installed, reboot your system to make sure that everything is working fine up to this point.
一旦新内核安装完毕,重新引导系统以确保到目前为止一切工作正常。
■Once this new kernel is installed you should reboot at the next available opportunity to get the benefit.
一旦新内核被安装,您应该重启来使用它,享受它的新功能。
■Note: The above values will take effect after the next reboot of the target computer.
上面的值会在目标计算机下一次重新启动时生效。
■Do you want setup to continue after next reboot?
下次重新启动后，安装程序要继续吗?
■Cannot create file needed for storing reboot information.
不能创建存储重新启动信息所需的文件。
■No, none of the compilers on HP-UX require a system reboot as part of the installation.
不需要，在 HP-UX 上安装任何编译器都不需要系统重新引导。
■Similarly to changing kernel parameters, once you reboot your system, any changes made to services will be lost.
与更改内核参数类似,一旦重新引导系统,则对这些服务的更改将会丢失。
■To reactivate sendmail, we can use chkconfig once more, but with the on argument. Start sendmail again to get it running immediately, not just after the next reboot.
为了让邮件服务器恢复功能,我们可以再次使用命令行工具.再一次启动邮件服务器以让它立即运行,而不是傻傻地等到系统的重新启动.
■Now you will have to reboot in order to telnet to the system.t.d/inetd start Now you will have to reboot in order to telnet to the system.
为帮助我们改进内容，请提供以下反馈意见和附加评论。如果有需要立即关注的问题或疑问，请提交呼叫，或与您的惠普响应中心联系。
■A reboot or shutdown to change the operating system configuration.
为更改操作系统配置而重新启动或关机。
■A reboot or shutdown to fix a problem with a hung application.
为纠正一个暂停应用程序的问题而重新启动或关机
■Try to reboot from hard disk.
从硬盘重启
■This normally results from a loss of the connection due to a timeout or a server reboot.
从连接由于超时或服务器重新启动损失，这通常的结果。
■Task registration is persistent, which is to say, it survives a crash and reboot.
任务的注册时持久的，就是说，它能在程序崩溃和重启中生存。
■But，it will clean the files on disk C: when you reboot your computer.
但是，当你重启计算机时，这个软件会清除在C盘上的文件。
■You must reboot after previous operation.
你必须在操作后重启.
■Ability To Shutdown,Logout &Reboot your PC and also to Force all of the above with out asking to save can be used to force a user only to use the pc for a period of time.
使用这个程序可以关闭、注销、重启动你的PC，也可以强制进行以上操作而不询问是否保存，这样可以限制用户只能使用PC一段时间。
■Fix for no drive found error message during a reboot.
修正系统没有发现驱动器的错误信息，提示重新启动。
■Shut down and reboot network computers.
关机和重新启动网络计算机。
■An unexpected error occurred shutting down the system. Please reboot.
关闭系统时,出现了一个异常错误。请重新启动。
■Kernel updates take effect when you reboot the system.
内核升级需要重启系统才会生效。
■Reboot again in normal mode and check if your issue is solved.
再次重启后以正常模式登陆系统看看你的问题是否解决。
■Out of memory preparing files for reboot.
准备用于重新启动的文件时出现内存不足。
■Did you get the reboot prompt? Type "reboot" and press enter, then log in again.
刚才你接到重启的提示了吗?键入“reboot”然后按回车,接着再次登入系统。使用你的已加密的系统。
■After your device is removed, setup will exit. Reboot your computer and run setup again to install a new infrared device.
删除设备后，安装程序将退出。请重新启动计算机，并重新运行安装程序，以安装新的红外线设备。
■You must reboot the machine before this component can be removed.
删除这个组件前，您必须重新启动机器。
■Press ENTER key to reboot the system.
加载成功，键入回车后，路由器重新启动。
■Please change terminal baudrate to 9600 BPS and press any key to reboot system.
加载程序完成，按任意键重启单板。
■KARSTEN: No, if you reboot the device, the mobile manager client will realise that the device is still in lock and scream mode and continue to scream.
卡斯滕：不是这样的。如果你重启设备，移动管理程序就会识别到手机仍处在锁定状态和尖叫模式，那么它就会继续尖叫。
■Simply insert your CD, reboot, and proceed to the next chapter.
只需要插入您的光碟,重开机,然后继续下一章。
■Run without using a virus scanner, adware/spyware protection, and not reboot my computer for months, even when I do keep up with all of the latest security updates.
可以裸奔(无杀毒软件，反广告/间谍防护软件)，以及可以数月不用重启机器，我甚至一直在更新着安全补丁。
■Run without using a virus scanner， adware/spyware protection， and not reboot my computer for months， even when I do keep up with all of the latest security updates.
可以裸奔（无杀毒软件，反广告/间谍防护软件），以及可以数月不用重启机器，我甚至一直在更新着安全补丁。
■You may need to reboot your machine. If that doesn't help, then in Control Panel, click Network, and then click Access Control to reinstall it.
可能需要重新启动计算机。如果问题依然存在，请单击“控制面板”上的“网络”图标，然后单击“访问控制”以重新安装。
■With the HP LaserJet series printer still connected directly, shut down the computer, turning it off and then back on to perform a reboot.
右键点击将要进行打印的打印机的名称，然后选择“属性”。
■Otherwise， you will get errors when performing a reconfiguration reboot.
否则，在执行重配置重新启动时将会出现错误。
■And in any event, a switch should never spontaneously reboot, no matter how burdensome the load.
和在任何情况下，开关绝不应自发地重新启动，无论怎样沉重的负担负载。
■English: Because making changes to a busy device may confuse the kernel, you are advised to reboot your computer.
因为更改一个忙碌装置可能使系统核心出现混乱，建议您重新启动您的电脑。