annealing
n. 低温退火, 锻烧, 热处理
动词anneal的现在分词形式
例句与用法:
Anneal means make harden steel soft and remove brittleness.
退火就是使淬火钢变软并消除其脆性。
词形变化:
动词过去式: annealed | 动词过去分词: annealed | 动词现在分词: annealing | 动词第三人称单数: anneals |
n.
锻炼; 磨炼
annealingannealing[æˈni:liŋ]n.1.■韧化; 热处理, 退火, 焖火2.■转色(试金)3.■熟炼过程4.■(意志等的)磨练, 锻练
annealing
名词 annealing:
hardening something by heat treatment
同义词:tempering
动词 anneal:
toughen (steel or glass) by a process of gradually heating and cooling
annealing
■An annealing backfire algorithm to get the parameters of BP ANN was presented.
:提出了反向传播人工神经网络 (BP ANN)参数学习的模拟退火 回火算法。
■The sub-micrometer-grain obtained by ECAP is still in sub-micrometer-grain averagely after annealing 8h at 573K, 1h at 623K, and 30min at 673K.
ECAP变形后获得的亚微晶组织 ,在 5 73K退火直到 8h、62 3K下退火1h、673K下退火 3 0min时 ,平均晶粒尺寸仍保持在亚微晶状态。
■PCR circulation includes DNA heat denaturation, initiators' anneal and links' extension.
PCR循环包括DNA热变性、引物退火、链的延伸三个步骤。
■On the surface of SnO2/Fe2O3 bilayer only a little amount of oxygen atoms were absorbed with and without annealing.
SnO_2/Fe_2O_3膜表面,热处理前后都只有少量的吸附氧,经热处理后表面吸附氧却略有增加.
■Three:they are hardening,temper and anneal.
三个过程:它们是淬火、回火和退火。
■Three . They are hardening, temper and anneal .
三种。 它们是淬火、回火和退火。
■Three. They are hardening, temper and anneal.
三种。它们是淬火、回火和退火。
■The stacking fault, the dislocation pile-up near grain and annealing twin boundaries, the dislocation cells and the de.
两种钢的形变结构中出现层错、晶界和退火孪晶处的位错塞积、位错胞状组织和形变孪晶。
■In this thesis, the formation of NiSi silicide using rapid thermal annealing is investigated.
中文摘要在此篇论文里,使用快速热退火去形成镍化矽的制程被研究。
■Grain size is small after intermediate annealing.Small and homogeneous grains are obtained after decarburizing annealing.
中间退火后晶粒细小,脱碳退火后晶粒细小均匀。
■Medium frequency transformer quenching is used for workpiece diathermy,quenching,annealing,brazing,etc.
中频淬火变压器用于工件的透热、淬火、退火、弯管钎焊等工艺。
■The results indicated that the algorithm of Simulating Anneal with Restriction (SA-MMI-R) has more advantages than others.
为了满足先验知识,设计了修正算法用于SA一MMI一R算法的结果修正。
■The long-term anneal behavior of the integrated dose record s -threshold voltage of PMOS dosimeters at room temperature has been studi ed.
为掌握PMOS剂量计的应用方式并提高其应用精度,研究了PMOS剂量计的辐照剂量记录-阈电压在室温下的长期退火表现。
■The primary concern is with the creation of neutral traps after aluminum metallurgy is in place, for then the required annealing is precluded.
主要关注的问题是当长好铝膜后中性陷阱的产生,所需要的退火将受到限制。
■The primary concern is with the creation of neutral traps after aluminum met allurgy is in place, for then the required annealing is precluded.
主要关注的问题是当长好铝膜后随着性陷阱的产生,所需要的退火将受到限制。
■The article introduces a way to confirm suitable annealing temperature of the aluminum alloy.
介绍了一种试验确定铝合金适宜退火温度的方法。
■All EBNER batch annealing furnaces in Tangshan Iron and Steel Group Company are introduced.
介绍了唐山钢铁集团公司所用EBNER罩式退火炉。
■Continuously Annealing Stove of Copper Tube Roller-Bottom Style Micoxidation from Arom America EF corporation.
从美国EF公司引进的铜管辊底式微氧连续退火炉。
■Therefor it forms another important basis for determination of annealing process parameters of aluminium foil.
从而为铝箔的退火工艺参数的确定提供了又一重要依据。
■In order to improve the efficiency and to make the optimization results better, the simulated annealing technique was embedded with genetic algorithm.
优化过程中,利用遗传算法进行结构优化,通过有限元技术对结构进行建模和分析。
■A gas station of ammonia dissociation for annealing line.
供退火线使用的氨分解气站。
■A liquefied petroleum gas station for annealing line.
供退火线使用的石油液化气站。
■Protective gas system: pipe line from the protective gas generation station to reducing annealing furnace.
保护气系统:从保护气体发生站至还原退火炉的管道。
■Characteristics of the Whole Hydrogen Bell-type Annealing Furnace and its Application to the Cold-rolling in Tiantie Group Co.
全氢罩式炉的特性及在天铁冷轧的应用。
■To do anneal process of bearing steel wire rod experiments with the furnace,a set of sphe...
冷拉轴承钢钢丝,无论中间品和成品,不论规格大小和变形量多少,可采用统一的退火工艺。
■Heat quench heat temper heat anneal heat correctitude.
分别是淬火,回火,退火,正火。
■Morphology and forming mechanism of annealing twin in medium carbon steels have been studied with optical microscope.
利用光学显微镜对中碳钢退火孪晶的形态及形成机制进行了研究。
■Design and application of the control system on the continuous annealing furnace in Beiman Special Steel Co.
北满特钢连续退火炉控制系统的设计及应用。
■Denaturing, annealing, and extending.
变性,退火,和延伸。
■It can replace traditional isothermal anneal as advance heat treatment of roughcast of bearing rings.
可部分替代传统的等温退火作为轴承套圈毛坯的预先热处理。
■Its original heat treament processes were graphitizing annealing,quenching and tempering,then high-frequency hardening.
同时因齿条形状特殊,高频淬火时易将齿部完全淬透,不能满足用户要求。
■P. J. N. van Laarhoven, E. H. L. Aarts , Simulated Annealing: Theory and Applications, Kluwer Academic Publishers 1987.
周鹏程,遗传演算法原理与应用,全华科技图书股份有限公司,2002.
■So the simulated annealing algorithm is introduced to solving the material balance equation.
因此,本文引入模拟退火算法求解物质平衡方程。
■The results show that through batch annealing after cold rolling, the steels exhibit excellent drawability and enamel ability.
因此综合考虑,采用罩式退火工艺可实现成型性能和贮氢性能的良好匹配。
■Difficulty can anneal one's best quality.
困难可以磨练出一个人最优秀的品质.
■The formation of a new set of strain-free grains within a previously cold-worked material; normally an annealing heat treatment is necessary.
在冷塑性变形材料的内部生成等轴状新晶粒的过程叫再结晶,通常发生于再结晶退火热处理过程中。
■This was the first time in our country that all quartz ceramics rolls were used in large scale continuous annealing furnace.
在大型连续退火炉中全部采用石英陶瓷辊在国内尚属首次。
■And a suggestion was made about proper softening annealing process.
在此基础上,提出了合理的软化退火工艺。
■Af-ter thermal annealing about 60% of radiation damage induced by implantation can be restored.
在热退火后,约60%的注入引起的辐射损伤可以得到恢复。
■Based on the features of distribution network, the improved genetic simulated annealing algorithm is used in network reconfiguration.
在考虑配电网自身特点的基础上,利用改进遗传模拟退火算法求解。
■In HLS-SVM model, the optimal parameters of LS-SVM were obtained by self-adaptive Particle Swarm Optimization (PSO) based on Simulated Annealing (SA).
在该方法中,最小二乘支持向量机的参数通过基于退火策略的自适应粒子群优化算法自动获得。
■In this process, films react with the active element in anneal atmosphere and recombine structure because of the high temperature.
在退火处理过程中,薄膜一方面与退火气氛中的活性物质发生反应,另一方面在高温作用下发生结构重组。
■During annealing of the cold-swaged alloy, the low-angle grain boundaries gradually disappear and the high-angle grain boundaries become predominant.
在退火过程中,合金中的小角晶界密度逐渐降低,大角晶界数量逐渐增多并最终成为主要晶界;
■In the process known as annealing , we heat the steel above the critical temperature and permit it to cool very slowly.
在通常所说的退火的热处理过程中,我们把钢加热到临界温度以上,再让它慢慢冷却。
■The Annealing Furnace is a key Equipment for any Hot Dip Galvanizing Line.
对于任何连续热镀锌线退火炉都是关键设备。
■There is no longitu-dinal surface caracking in the course of acid pickling after the stress reliving annealing.
对冲压后的磁屏采用消除应力退火,随后再酸洗,未发生表面轴向开裂。
■The harmness of the hydrogen frangibility is discussed,and then the appropriate conditions of vacuum anneal are gained.
对氢脆的危害进行了探讨,得出了适宜的真空退火条件。
■The XRD, SEM analysis, the oxidation weigh loss and annealing circulation experiment with the coating are done.
对涂层进行了XRD、SEM分析、氧化失重实验和热循环实验。
■The as-deposited high silicon electrical steel was processed using high temperature rapid annealing process.
对电子束物理气相沉积高硅硅钢片进行了高温快速退火处理。
■The influence of annealing,degreasing,electropolishing on the morphology of porous anodic alumina was investigated.
对铝的预处理工艺进行了研究,详细探讨了高温退火、除油及电化学抛光等对多孔阳极氧化铝形貌的影响。